3. Insert the screwdriver into the hole, turn the drive of oil pump shaft untill parallel to
the crankshaft (
See Fig. 48,49
)
Figure 48 Figure 49
4. Align the mark 2 on the shaft of distributor to the mark 1 on the aluminum housing
(
See Fig. 50
)
Figure 50
5. Insert the distributor slowly to the hole (
See Fig. 51
). Confirm the direction of
distributor is as per the figure (
See Fig. 52, 53
). Tighten the nut of distributor housing.
Figure 51
41
