17
I. EASY FIT connection
ASSEMLING THE CAR SEAT (fig. 2).
The car seat consists of three components: adjustable headrest, backrest and booster.
Place the backrest in a flat position behind the seat and rotate the backrest to the vertical position until
you hear a clear click. (fig. 14). Make sure that the two units are correctly assembled.
Insert the headrest into the upper recess of the backrest and push it downwards until you hear a click. The
subsequent clicks are used to adjust the headrest in height.
ADJUSTING THE HEADREST
Regularly check if the headrest is at a suitable height for your child. The height of the headrest is correct
and corresponds with the size of the baby when the child’s head rests comfortably in the middle.
You can adjust the height of the headrest by holding the backrest with one hand and pulling the headrest
upwards (or pushing it down) with the other, gripping the upper part. You will hear a “click” when it is
positioned at the desired height.
INSTALLATION OF GROUP II/III (15-36 kg) (Fig. 3-4-5)
Press the EASY FIT release button to pull out both EASY FIT connectors to the maximum.
Place the child car seat in a suitable forward facing position and match the EASY FIT connectors at the
ISOFIX anchorage points of the car seat and insert the connectors into the anchorage points until they
close with a “click”.
Match the EASYFIT connectors to the vehicles ISOFIX anchoring point until you hear a “click”. The
indicators on each connector should turn from red to green. Ensure both stirrups are correctly engaged.
Push the car seat by exerting equal pressure on both sides until the rear of the car seat is pressed firmly
against the vehicle seat.
Grasp the body of the seat to check if the seat is securely fastened or swings. If the seat swings and the
ISOFIX connectors come out, please repeat the previous steps and install it again.
PLACING YOUR CHILD IN THE CAR SEAT (Fig. 6-7-8-9)
Position the car seat so that the backrest sits firmly against the back of the passenger seat.
Place the child in the seat. Secure the child using the 3-points seat belts by passing the diagonal belt of
the vehicle through the belt guide under the headrest (C/F) and the lap belt above the child and below
the two armrests and fasten the buckle until you hear a “click”. Tighten the lap belt so that it fits closely.
Make sure that the belt is correctly fitted.
WARNING:
Make sure that the belt is not twisted.
REMOVING THE CAR SEAT(Fig. 10)
Press EASY FIT release button from both sides to release the ISOFIX connectors and remove the car seat.
