Jøtul GI 550 DV, Инструкция по установке и эксплуатации

Страница: 3 / 32

3
138727_Rev_F 8/9/11
Table of Contents
Installation & Service Tools .........2
Specifications ....................................4
General Information ........................5
Safety Information ..........................6
Installation
Fireplace Requirements .............. 7
Hearth Protection ..........................8
Clearances ........................................8
Masonry Fireplaces .....................10
Prefabricated Fireplaces ...............11
Vent Requirements .......................13
Fireplace Assembly
Gas Connection ............................. 14
Gas Pressure....................................15
Fuel Conversion .............................16
Wall Thermostat ........................... 18
Remote Control ............................. 18
Blower Power Requirement ....... 18
Optional Wall Panel Kits .............19
Log Set Installation ..................... 20
System Check..................................21
Surround Assembly ......................22
Operation
Burner Controls ............................23
Blower Controls ...........................24
Maintenance
Annual Cleaning ...........................24
Glass Replacement .......................25
Illustrated Part Breakdown ........ 26
Replacement Parts List ..................27
Appendix A:
Remote Installation
.....28
Service Log ...................................... 30
Lighting Instructions ......................31
Figure 1. Pull each Spring Latch out and down to
disengage it from the Glass Frame.
Latch
Release
Tool
Left Latch
Release
Unpacking the Fireplace
• A Miscellaneous Hardware Kit is packed within the
right side compartment of the firebox. It contains:
• Installation / Operation manual
• Glass Frame Latch Release tool
• Fuel Conversion Kit, LP
• Leg Leveller Brackets, - left and right, 2 each
• #10 x 1/2” Sheet metal screws for brackets, 8
• Rock Wool
• The Log Set is packaged separately from the
firebox. Use the Latch Release tool to remove the
fireplace glass frame in order to install the log set
and any other accessories.
• See the cut-away view in fig. 1 below to locate the
right and left spring latches on the underside of
the firebox floor. Release each latch by engaging
the tangs of the tool with the latch throat, pulling
it forward and down.
• Pull the Glass Frame away from the Firebox and lift
to disengage it from the retaining lip at the top of
the firebox. Set the glass out of the way.
• Do not unpack the log parts until you are ready to
install them.