11
4.5 Installing the cast iron sides
Fig. 16
A
1. If installing the fl ue pipe at the back, the removable cover
plates
(A)
must be knocked out.
Fig. 17
A
B
C
E
D
2. Loosen the screw
(A)
for the cast iron side on the top.
3. Unhook the lower part of the side with the screw on the
bracket
(B)
. Secure on the underside with a nut and
washer
(E)
.
4. Push the upper bracket over the screw hole
(C)
on the top
of the burn chamber.
5. Secure the bracket with a screw
(A)
and nut
(D)
.
6. Secure the other side in the same way
4.6 Fitting a fl ue pipe with a top outlet
The product is supplied from the factory with the smoke outlet
fi tted for the top outlet.
1. Place the product in the correct position
(fi g. 1)
.
2. Place the top plate and the grate on top of the product.
3. Place the gasket on the edge of the flue pipe as illustrated
in
Fig. 15 B
.
4. Move the flue pipe into position.
NB: It is important for the joints/fl ue pipes to be sealed
completely. Air leaks may prevent them from operating
properly.
4.7 Adjusting the burn chamber height
for the Jøtul F 480
Any unevenness between the burn chamber and the base/
pedestal/foot must be corrected.
This may also be done to reduce pressure on the draught
valves (prevents draught valves from becoming stiff).
Fig. 18
A
A
B
B
1. If the base has been mounted, the shelf and the inner plate
must be removed fi rst.
2. Unscrew
the
screws
(A)
approx. 4 mm on both sides of the
product.
3. Unscrew
B
using an Allen key until you feel resistance in
the key. Then turn the adjustment screw to raise the burn
chamber as much as required.
4. Finally, tighten screws
A
.
5. Refi t the base inner plate and shelf (only for base).
ENGLISH
Содержание F480
Страница 86: ...86...
