EN
FR ES
!
WARNING
Child may slip into leg openings and strangle.
Never use in reclined carriage position unless the foot enclosure is properly attached.
Use carriage position for babies from birth to 3 months.
Use fully upright seat position for children 6 months and above ONLY.
Use other reclined seat positions for children 3 months and above ONLY.
10 Installing/Removing the Bumper Bar
• Position the bumper bar so that the buttons face downward. Then line up the holes on the bumper bar with the posts on the stroller and
push them in until the bumper bar clicks into place.
See Figure 10.1.
• Pull on the bumper bar to ensure it is secure.
• To remove the bumper bar, press the buttons underneath either side of the bar simultaneously.
See Figure 10.2.
Then pull the bumper bar
away from the stroller
!
WARNING
The bumper bar is not a restraint device. ALWAYS secure your child with the restraint system. NEVER lift the stroller
by the bumper bar. Use caution when attaching the bumper bar when there is a child seated in the stroller.
11 Securing the Child
• There are three height adjustment positions for the shoulder harness. Adjust the height to the closest height above your child’s shoulders.
• To remove the shoulder harness, turn the plastic ends sideways and push them through the slots in the seatback. Reattach the harness at
the proper height by reinserting the plastic ends through the slots.
See Figure 11.1.
Ensure both straps are the same height.
• To unlatch the buckle press the center button and remove the male ends of each buckle.
See Figure 11.2.
• Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the
child’s legs.
• Push the shoulder/waist latch posts into the crotch buckle until all parts snap into place.
See Figure 11.3.
• Tighten the waist belt to be snug around the child’s waist.
• The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings on these straps.
!
WARNING
Avoid serious injury from falling or sliding out. Always use the restraint system.
12 Adjusting the Handlebar
The handlebar can switch from front to back position.
• To adjust the handlebar direction, pull up on the release levers on both sides of the handle.
See Figure 12.1.
Push the handle to desired
direction until it snaps into place.
See Figure 12.2.
13 Storage Basket
The maximum weight that can be carried in the storage basket is 5 lbs. (2.27 kg).
14 Attaching/Removing the Cup Holders
• Attach the cup holder by sliding it down onto either peg on the outside of the handlebar.
See Figure 14.1.
The cup holder can be adjusted
to the desired angle. Repeat on the other side if desired.
• Slide the cup holder up to remove.
!
WARNING
For use ONLY on the Joovy Balloon stroller.
The total weight that can be placed in the cup holder should be less than 1 lb. (0.45 kg).
NEVER carry hot beverages or open containers in this product.
15 Folding the Stroller
• Keep children away from stroller while folding.
• Make sure both rear wheel brakes are set to their locked positions.
• Make sure the handle is directed towards the BACK of the stroller.
• Move the release tab to the right and squeeze the button below.
See Figure 15.1.
Push down and forward on the handlebar.
See Figure 15.2.
!
WARNING
ALWAYS keep children away from the stroller when folding.
Possible pinching hazard – Be careful when folding the stroller.