EN
FR ES
3 Installing Rear Wheels
• Turn stroller upside down.
• Place the rear wheels onto the rear wheel posts until they click in place.
See Figure 3.1.
The brakes should be facing the rear.
• Pull on the wheels to ensure they are installed properly.
4 Installing Front Wheels
• Tilt the stroller so it is resting on the rear wheels and the handle bar.
• Place the front wheels onto the front wheel posts until they click in place.
See Figure 4.1.
• Pull on the wheels to ensure they are installed properly.
5 Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, lift the locking lever located between the wheels until a click is heard.
See Figure 5.1.
Rotate the wheel set until it
locks automatically in the straight position.
• To unlock the wheels (swivel mode) push down on the locking lever.
6 Operating the Canopy
• The canopy can be adjusted to be fully opened or closed.
See Figure 6.1.
• To remove, recline the seat fully. Press the release buttons and pull up on the canopy.
See Figure 6.2.
• To install, line up the tabs with the slots on the stroller and push them in until the canopy clicks into place.
!
WARNING
Possible pinching hazard – Be careful of the side hinges when opening and closing the canopy.
7 Rear Wheel Brakes
• Always engage rear brakes before placing child in or removing a child from the stroller.
• To engage the brakes, push down on both of the brake levers until the brake snaps in place.
See Figure 7.1.
• Check that BOTH wheel brakes are properly engaged.
• To release the brakes, lift up on the brake lever.
See Figure 7.2.
!
WARNING
Always make sure the wheel brakes are engaged when the stroller is not
being pushed so that the stroller will not roll away.
Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide.
8 Adjusting the Leg Support
• To adjust the leg support, locate the tab underneath the leg support, pull the tab forward and place the leg support into the desired
position.
See Figure 8.1.
!
WARNING
NEVER allow a child to step onto or sit on the leg support or footrest. This may cause the stroller to tip over and
injure the child.
9 Seat Back Position and Carriage Position
The seat can be adjusted to any position from upright to fully reclined. Use carriage (flat) position for babies from birth to 3 months (foot
enclosure must be installed). Use fully upright seat position for children 6 months and above ONLY. Use other reclined seat positions for
children 3 months and above ONLY.
• Locate the recline mechanism on the back of the seat.
• To recline the seat, grasp the recline mechanism, squeeze on both sides, and gently pull toward the rear of the stroller until the seat is in
the desired position.
See Figure 9.1.
• To adjust the seat to a more upright position, pull both straps at the end of the recline mechanism outward until the seat is in the desired
position.
See Figure 9.2.
To Use the Carriage (Flat) Position for Infants from Birth to 3 Months
• Fully recline the seat.
• Adjust the leg support to the uppermost position.
• Locate the foot enclosure in the pocket beneath the leg support. Attach the foot enclosure over the leg support by securing the loop
around the peg on BOTH sides of the stroller.
See Figure 9.3.
• When not in use, store the foot enclosure in the pocket beneath the leg support.
