- 24 -
GEAR OIL REPLACEMENT
Replace the gear oil after initial riding
for300km, then replace again after every
half year or 3000km later.
Do as below described for replacement:
1. Put the scooter on the center stand.
2. Place an oil pan under the gear case.
3.Remove the oil filler bolt and the drain
plug to drain the oil.
4.Reinstall and tighten the drain plug.
5.Fill the gear case with oil.
Recommended oil: API GL-3 SAE 85W/140
Oil capacity : 0.11 L
-
25-
!!!WARNING
Do not let foreign material enter the gear
case. Be sure oil does not get on the tire or
wheel
6. Reinstall the oil filler bolt.
7. After replacing the gear oil, be sure to
check the oil leakage.
CLEANING OF ALR CLEANER
The air cleaner should be cleaned at the specified
intervals .it should be cleaned more frequently if you
are riding in usually wet or dusty areas.
1. Place the scooter on the center stand.
2. Remove the left side panel by removing the screws
on it
3. Remove the air cleaner cover by removing screws
on it.
4.Take out the air cleaner, and remove the screws on
it.
5.Remove the air cleaner element and wash it gently,
but thoroughly in solvent .if it is damaged replace it.
6. Squeeze out the excess solvent and dry it
7. Apply oil to the entire surface of the air cleaner and
squeeze out the excess oil .it should be damp but not
dripping
Recommended oil :same as engine oil.
- 26-
8.Install the air cleaner and the air cleaner
cover
CAUTION
Drain the oil accumulated in the red tube
after every 1000km riding
SPARK PLUG INSPECTION
Specified Spark Plug:
