Jonsered FR 2216 A 4X4, Руководство оператора

Страница: 28 / 40

28 –
English
Maintenance
The ground pressure should be between 12 and 15 kg (26.5-
33 lb).
Checking the cutting unit’s
parallelism
Check the cutting unit’s parallelism as follows:
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2 Place the machine on a flat surface.
3 Measure the distance between the ground and cutting
unit’s edge at the front of the cover.
The cutting unit should have a slight slant, with the rear edge
2-4 mm (1/8”) higher than the front edge.
Adjusting the parallelism of the
cutting unit
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2 Remove the front hood and right-hand fender.
3 Undo the nuts on the lift strut.
4 Screw out (extend) the stay to raise the rear edge of the
cover.
Screw in (shorten) the stay to lower the rear edge of the
cover.
5 Tighten the nuts against each other after adjustment.
6 On completion of the adjustment the unit’s parallelism
should be re-checked.
7 Fit the right-hand fender and the front hood.
Service position for the cutting unit
The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position Combi 94
1 Position the machine on flat ground. Apply and lock the
parking brake. Set the cutting height control in the lowest
position and lift up the cutting unit.
2 Remove the front hood by removing the pin.
3 Loosen the spring on the drive belt’s belt idler by
loosening the handle.
4 Place the handle on the frame arch.
1
2