Jonco RATEL RC180 D, Руководство пользователя

Страница: 44 / 46

Chipper
Problem Possible reason Adjustment and maintenance
Feeding is not
good.
blunt blade Reverse or replace
Belt is too loose Adjust belt tension
Wrong blade edge angle Angle is 31 degree
Hopper blocked Stop engine, lift up roller, clean material jammed
Drum bearing
overheated
Max 210°F/99℃
Lack of lubricant Cool down, lubricant
RPM is too high Less than 2400rpm
Jammed in
output chute Drum rpm is too low
Blunt blade Clean up material jammed, and run machine at max
speed.
Drum shaking
Shaft sleeve gets loose
Bearing holder gets loose
Bearing gets worn
Too much debris jammed behind
bearing holder
Tighten torque is 108nm
Tighten torque is 108nm
Replace bearing
Clean up bearing holder
Drum stuck
Material jammed in housing
Bearing stuck during worn parts Stop machine and clean up
Check and replace bearing if needed
Trouble shooting table
Pr oble m Reaso n Solut ion
A b n o r m a l n o i s e A i r i n s y s t e m
C h e c k a n d r e p l ac e t u b e o r c o u p l e r w o r n o r c r a c k e d .
K e e p t h e o i l l e v e l i n t h e t a n k a t 3 / 4
Pump
43