XBASE 999 Operating Manual
61
Muting Instruments
Tune
Pitch
Snappy/Cut
LP Cutoff
Attack
Decay
Peaktime/Q
HP Cutoff/Q
Harmonics
1
5
BD Mute/ Vol
HH Mute /Vol
R ID Mute/Vo l
SD Mute/V ol
CLP Mute/Vol
LT M ut e/V ol
RIM Mute/Vol
HT Mute/Vol
CR H Mut e/Vol
9
2
6
3
7
4
8
At any time and in any mode, you can mute the instruments by
clicking on one of the displayed encoders 1-9. When the instrument
is muted, the corresponding LEDs blinks red.
» Note
: The filter runs aside of the audio engine and is mixed into the
stereo bus. Thus it may occur on some filter setups that the filtered
instruments are still in the mix bus apparent although they are muted. Now
they can be muted by encoder 16 (filter mute) or by different filter
programming (see The Filter page 47).
It has been purposefully made like this because you can free decide if you
want a filtered, pure, mixed or even no signal. You can also handle the filter
as an own instrument (For instance for resonating basses).
The individual outputs are not affected by this since the signal is split out
before the filter which only works in the stereo mix bus.