14
Use Front Swivel Lock
Push down the front swivel locks to maintain the moving direction.
19
Tip
It is recommended to use swivel locks on uneven surfaces.
Use Brake
To lock wheels, step the brake lever downwards.
20
To release wheels, just lift the brake lever upwards.
21
Tip
Always apply brake when stroller is in stopped position.
Use Hood
The hood can be opened or folded, pull it toward front or back.
The hood can be opened completely to protect your child from the sun
uttermostly, just unzip the hook
22
- 1
, and then pull the hood toward front.
There is a window on the hood, through which you can view your baby.
Roll up the backward panel and stick the hook and loop fastener, then you
can view your baby.
22
- 2
Use Tether Strap
Use the tether strap to prevent the stroller inadvertently rolling away.
If you cannot easily control the stroller move the tether to a different
position.
1. To disassemble tether strap. Select a position high up on the handle and
wrap the tether strap around the handle and thread the larger loop
through the smaller loop, pull tight.
23
2. Check that when your hand is through the loop, the position selected
allows you to easily control the stroller.
Fold Stroller
!
Please fold the hood before folding the stroller.
Pull the folding webbing upward, the frame will automatically fold
backward.
25
- 1
The storage latch will automatically hook onto the storage mount, then the
stroller is folded and locked completely.
25
- 2
Use Accessories
Accessories may be sold separately or may not be available depending on
region.
Use Footmuff
The soft footmuff can provide your child with a warm and comfortable
environment.
Assemble the footmuff by following these steps.
1. Place the footmuff over the seat after unziping it, thread the shoulder
harnesses, waist harnesses and crotch harness through respective
slots.
27
2. Thread loop fastener on the top of the footmuff through the backrest, and
then stick it to the hook fastener.
28
3. Place baby into the footmuff, lock the safety buckle, and then rezip
the footmuff.
The assembled footmuff is shown as
29
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 8
pairs of hook and loop fasteners on the rain cover.
30
!
Before using the rain cover, please make sure the backrest has been
adjusted to the lowest position and the infant child restraint has been
fastened.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and
dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during
hot weather.
Care and Maintenance
!
Removable seat pad may be washed in cold water and drip-dried. No
bleach.
!
To clean stroller frame, use only household soap and warm water. No
bleach or detergent.
!
From time to time, check your stroller for loose screws, worn parts,torn
material or stitching. Replace or repair the parts as needed.
!
Excessive exposure to sun or heat could cause fading or warping of
parts.
!
If stroller becomes wet, open hood and allow to dry thoroughly before
storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing
machine oil). It is important to get the oil into the axle and wheel
assembly.
26
!
When using your stroller at the beach, completely clean your stroller after
use to remove sand and salt from mechanisms and wheel assemblies.
13
