Surface Technology
Oberflächentechnik
1
2
3
11
Figure 7.2 Control elements (back side)
1 – Connection socket for foot control FC-64
2 – 230 V mains fuse
3 – Connection socket for 230 V mains cable
Figure 7.2/1:
As soon as the connection socket for foot control is connected with
the unit, the foot control will be active.
Figure 7.2/2:
If the unit fails to function after switching on the mains switch, initially
check this fuse (see – fuse replacement). The 230 V fine fuse is loca-
ted behind the cover.
Figure 7.1/10 and 7.1/14: The connection socket A or B is selected by pressing the pushbuttons
for motor B or A.
Figure 7.1/12:
Load monitor LED
The six LED’s (3 green, 2 orange and 1 red) indicate the load bearing
capacity during the working process. Ideally, only the three green
LED’s should illuminate during prolonged working processes.
Figure 7.1/11 and 7.1/13: By illuminating, the LED’s next to the pushbuttons show the respective
set operating mode.
Figure 7.1/18:
On/Off switch
The micromotor can be switched on and off on the motor cable
(7.1/19).
