16
Check that the float housing is properly mounted, and the machine is
ready for the correct cleaning method, if not:
• remove the kit for wet vacuuming.
• empty the tub of any debris and dirt.
• clean the tub with water and leave to dry.
Emptying after wet vacuuming with vacumat 12, 22
The soiled solution picked up must be disposed of according to the national
regulations.
Wet vacuuming vacumat 22T
Dry suction with vacumat 12, 22, 22T
Beginning work
End of operation
• Place the double-filter sack over the hose
support.
T
he rubber flange of the double-fliter paper sack
must
be behind the ridge of the hose support!
• Insert the filter basket.
The arrow must point towards the hose support.
• Place the ridge of the suction top into the catch
as shown, then press down until you hear the
fastener catch click into place.
• Assemble the dry suction set.
• Attach the suction hose (squeegee) to the connector.
• Press the locking device on the hose connector and remove the hose.
• 1Pull the fastening catch (1) upwards and lift off
the suction top.
• Remove the float housing.
Tilt function vacumat 22T
• Hold the chassis and slowly tilt the tub to empty.
Carrying function vacumat 22T
• Push the levers that connect the tub to the tilting
frame outwards.
• You will now be able to lift the tub from the frame
and empty it.
• Rinse the tub and float housing with water.
The float housing and its contents must be thoroughly cleaned after every
use (Page 17).
Never store the machine when it is wet. Allow the machine to dry
out in th air before assembling.
This will reduce the build up of unpleasant smells and mould.
• Insert the float housing back into place.
The arrow must point towards the hose support.
• Place the ridge of the suction top into the catch
as shown, then press down until you hear the
fastener catch click into place.
1
2
1
2
1
2
• Lift and push the squeegee holder towards the tub and lower the Fixomat
squeegee.
The Fixomat squeegee is in the parking position.
• Press the locking device on the hose connector and remove the hose.
• Loosen the fixation screws on the squeegee.
• Remove the squeegee and re-tighten the screws.
• Clean the Fixomat squeegee with water using a brush.
• Pull the fastening catch (1) and lift off the
suction top.
• Take out the filter basket, check if the sponge
filter is dirty, clean if necessary.
Caution:
Do not vacuum objects such as screws and other metal parts or
objects that may cause damage to the machine!
• Connect the power supply cable to the mains socket and press the On / Off
switch to begin operation.
Caution:
When the nominal consumption is reached while wet vacuuming,
the float will cut off the air suction.
No more liquid will be vacuumed and the machine must be turned
off. and drained
If while wet vacuuming, the vacumat 22T leaves residue, use the
height adjustment screw for the squeegee to lower it.
• Switch the machine off (ON/OFF) and pull the power supply cord out of the
mains socket.
• Wipe down the machine with a damp cloth.
• Loosely coil the power supply cord and tuck it underneath the machine
handle.
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
1
2
1
2
