Johnson T8000PRO, Руководство по обслуживанию

Страница: 36 / 49

36
[Symptom]
Press start then the console display show “Error 3 or 6“
[Cause]
1. The 20-pin console cable is damaged.
2. Incline motor is damaged.
3. PCB is damaged.
4. Incline power board is damaged.
5. The incline setting is not correct.
[Solution]
1.Enter the “Engineer mode” to P4:LOW ELEVATION this ADDRESS place,
press the “SELECT” key , console display will show incline motor parameter
(Please refer the below photo), if display not show right parameter, please check
the between Incline power board and incline motor whether connect is OK, if it
is OK, please replace new console cable to test again.
2. If display still show “Error 3 or 6“, please replace the incline motor.
3. If display still show “Error 3 or 6“, please replace the PCB.
4. If display still show “Error 3 or 6“, please replace the incline power board.
5. Enter Engineering Mode to
Auto-calibration
place to renew the
Auto-
calibration
elevation parameter (Please refer the page 25) .
Error message 3,6 troubleshooting
Incline motor right
now place parameter
Incline motor Default
Value place parameter