Johnson Pumps AQUA JET WPS 2.9, Инструкция по эксплуатации

Страница: 10 / 52

0
Wiring dimensions
(based on 3% voltage drop)
WPS 2.9
Wire size Max wire
lenght* in m
V 4 V
,5 mm² # 6 AWG 5
,5 mm² # 4 AWG 8 34
4,0 mm² # AWG 3 55
6,0 mm² # 0 AWG 9 8
WPS 3.5
Wire size Max wire
lenght* in m
V 4 V
,5 mm² # 4 AWG 5
4,0 mm² # AWG 8 34
6,0 mm² # 0 AWG 3 5
0 mm² # 6 AWG 9 8
WPS 4.0
Wire size Max wire
lenght* in m
V 4 V
,5 mm² # 4 AWG 7 30
4,0 mm² # AWG 49
6,0 mm² # 0 AWG 6 73
0 mm² # 6 AWG 7
WPS 5.2
Wire size Max wire
lenght* in m
V 4 V
,5 mm² # 4 AWG 5
4,0 mm² # AWG 8 34
6,0 mm² # 0 AWG 5
0 mm² # 6 AWG 0 86
6 mm² # 4 AWG 3 38
* The wire length is the total distance from the
©battery to the pump and back to the battery.
It is recommended to use a relay with a light
wire from main cable to switch to shorten the
main leaders.
enGLISH
note: Before installation with electrical
control systems, check that equipment
to be used is of sufficient rated capacity
to accept amperage draw of motor. Low
voltage will cause motor to overheat.
Maintenance
The system shall be periodically
sanitized using the following procedure:
. Fill the tank with a solution of house-
hold bleach and potable water –
ml (.03 oz.) bleach/ l (3 oz.) water.
. Open all faucets and run until water
flowing smells of bleach.
3. Close all fauces.
4. Drain solution from tank.
5. Refill tank with potable water.
6. Open all faucets and run until
bleach has been purged.
Wiring table
Pump
Terminal
fuse
Switch
Max 0.2
m
Red
Black
Green/yellow
+
–
Other electrical devices, eg switch, circuit
breaker, must be installed between the
pump and the positive (+) lead on the bat-
tery (on the red wire).