ZFR1812 Wall Mount Wireless Field Bus Router Installation Instructions
3
IMPORTANT:
The label showing the unit MAC
address is on the plastic base of the unit. Be sure to
keep the plastic base and circuit board assemblies
together so the correct MAC address is shown.
2.
Decide whether you are mounting on a wall or
ceiling.
a.
For flush wall mount applications, determine
where to secure the plastic base to the surface
using the mounting holes and supplied screws.
A template (Figure 11) is provided at the end of
this document to help you place the mounting
holes.
b.
For ceiling mount applications, mount the
ZFR1812 to the grid between the tiles. There
are a number of ceiling mounting clips
available from third parties which can be used.
Make sure to match the clip you purchase to
the grid in the location where you are doing the
installation. Ceiling grid dimensions and offsets
vary, so using an incorrectly sized clip may
prevent mounting the ZFR1812 flush for a
professional appearance. A hole is provided in
the base of the assembly for this purpose
(Figure 3).
IMPORTANT:
If you are using a ceiling mounting clip
you must make sure that no part of the clip makes
contact with the circuit board assembly when installed.
3.
Assemble the external power and adapters as
necessary (Figure 4).
a.
The 24 VAC to 15 VDC power supply (1) uses
screw terminals to attach to a 24 volt source.
b.
The adapter connects the 15 VDC output of the
power supply to an RJ12 adapter (2). Plug this
adapter directly to the cable coming from the
ZFR1812 through a connector (3).
c.
This connector (3) is then used to connect to
the 10 ft RJ-12 cable which is attached to the
ZFR.
Note:
Any inline adapter used to extend the
connection of the ZFR1812 to a controller or power
must be a straight through
adapter instead of
crossover.
4.
Set the DIP switches. See
.
5.
Reattach the circuit board assembly in the plastic
base.
Figure 2: ZFR1812 Wireless Field Bus Router,
with Plastic Base and Circuit Board Assy
Separated
Figure 3: ZFR1812 Wireless Field Bus Router,
with Plastic Base Hole for Ceiling Mount
