Installation Instructions
M9106-xGx-2
Issue Date
June 30, 2014
© 2014 Johnson Controls, Inc.
1
Part No. 34-636-1085, Rev. D
www.johnsoncontrols.com
M9106-xGx-2 Series Electric
Non-Spring Return Actuators
Installation
IMPORTANT:
Use this M9106-xGx-2 Series
actuator only as an operating control. Where failure
or malfunction of the this M9106-xGx-2 actuator
could lead to personal injury or property damage to
the controlled equipment or other property,
additional precautions must be designed into the
control system. Incorporate and maintain other
devices, such as supervisory or alarm systems or
safety or limit controls, intended to warn of or protect
against failure or malfunction of the M9106-xGx-2
Series actuator.
Utiliser ce M9106-xGx-2 Series actuator uniquement
en tant que dispositif de contrôle de fonctionnement.
Lorsqu'une défaillance ou un dysfonctionnement du
M9106-xGx-2 actuator risque de provoquer des
blessures ou d'endommager l'équipement contrôlé
ou un autre équipement, la conception du système
de contrôle doit intégrer des dispositifs de protection
supplémentaires. Veiller dans ce cas à intégrer de
façon permanente d'autres dispositifs, tels que des
systèmes de supervision ou d'alarme, ou des
dispositifs de sécurité ou de limitation, ayant une
fonction d'avertissement ou de protection en cas de
défaillance ou de dysfonctionnement du
M9106-xGx-2 Series actuator.
Parts Included
•
M9106-xGx-2 actuator
•
M9000-160 anti-rotation bracket
•
two No. 12-24 x 1/2 in. self-tapping hex
washer-head screws
•
spade terminals
Special Tools Needed
•
drill with a 3/16 in. (No. 15, 4.57 mm) drill bit
•
5/16 in. (8 mm) square socket or 3/8 in.(10 mm)
12-point socket
•
wire/terminal crimper
Mounting
The actuators are not position sensitive, and may be
mounted in any convenient orientation. They may be
installed on a 3/8 to 1/2 in. (10 to 12.7 mm) round shaft
or a 3/8 in. (10 mm) square shaft, 1.7 in. (43 mm) or
longer. If the shaft is less than 1.7 in. (43 mm), install
an extension recommended by the damper
manufacturer.
To mount the actuator, proceed as follows:
1. Press and hold the gear release lever, and rotate
the coupler to the 0 or 90° position. Release the
gear release lever. (See Figure 1.)
90
0
60
30
0
90
30
60
Anti-rotation
Bracket
Coupler
Set Screw
Shaft
Center
Coupler
A
Damper
Frame
or Duct
Gear
Release
“A” is the distance from the center of the holes in
the anti-rotation bracket to the center of the shaft.
(See Table 1.)
Note:
Figure 1: Mounting Positions
Table 1: Distances from the Anti-rotation
Bracket to the Shaft Center
Shaft Diameter
1/2 in.
3/8 in.
“A” Dimensions
5-1/8 in.
5-1/16 in.
(See Figure 1.)
130 mm
128 mm
