Johnson Controls LN-DSWSC1-0, Руководство по установке, Страница: 3 / 8

LN-Display Installation Instructions 3
North American Electrical Box
To mount the North American Electrical Box:
1. Remove the Display panel from the device by
gently pressing on the panel and pulling the front
panel outward (Figure 3).
2. Select a mounting location.
3. Pull the power and network communication wires
until they extend 6 in. (152 mm) from the electrical
box.
4. Pull the power and network communication wires
through the wire exit hole (Figure 4).
5. Position the base plate on the electrical box.
6. Mount the base plate using the screws provided
with the electrical box.
7. Connect the power and network communication
wires. See the
Wiring section for more information.
8. Reattach the front panel to the base plate by
pressing gently on the Display until the panel clicks
into place.
European Electrical Box
Follow the steps in the North American Electrical Box
section.
DIN Rail
To mount on a DIN rail:
1. Remove the Display panel from the device by
gently pressing on the panel and pulling the front
panel outward (Figure 3).
2. Break off the tabs to expose the DIN rail channels
in the base plate (Figure 5).
3. Break off the cover from the exit hole (Figure 5).
4. Pull the power and network communication wires
through the wire exit hole
5. Slide the back plate onto the DIN rail (Figure 6).
Figure 3: Removing the Surface Mount
Casing
FI
G
: C
as
in
g
Figure 4: Mounting Screw Holes
FI
G
: ho
les
3 3
2
4 4
2
3
3
1. Wire exit hole
2. Mounting screw holes for 2x4 electrical boxes
3. Mounting screw holes for 4x4 electrical boxes
4. Mounting screw holes for 1/4 DIN electrical boxes
1
Break-off tabs for
Din Rail mounting
Wire exit hole
break-off cover
Figure 5: DIN Rail Installation – Break Off
Figure 6: DIN Rail Mounted
FI
G
: d
in
_
ra
il