090.510-M (OCT 10) FRICK
QUANTUM™LX AcuAir
CONTROL PANEL
Page 22 MAINTENANCE
ANALOG BOARD SETTINGS
Communications
The following table is to be used when configuring the Quantum™ for external communications.
LK1
In
Out *
120 ohm long communications line termination.
No termination.
* default setting
Miscellaneous
LK2
In
Out *
Not Used
LK3
In
Out *
Not Used
LK4
In
Out *
Not Used
* default setting
NOTE:
Although LK2, 3 and 4 are not used, they must still be set for the default positions.
Dipswitch Settings (Used to set the board address)
The following table is to be used to set the analog board address. These switches must be set as shown below:
SW1
SW2
SW3
SW4
SW5
SW6 SW7 SW8
Board #1
Off
Off
Off
Off
Off
Off
Off
Off
