8. Test Run with the Controller
1. Turn ON the power supply for the indoor units.
The “
” light (yellow) on the receiver kit of the indoor unit flashes (0.25 seconds ON
0.25 seconds
OFF), and then turns OFF. While the light is flashing, the unit will not operate because it is initializing.
2. Set the Test Run mode by pressing the “Louver”
button and “On Timer” button for three seconds at
OFF. The LCD will display as shown at right.
3. Set the operation mode by pressing the “Mode”
button.
Test Run timer
mode.
Unit is running
under Test mode.
4. Operate the Test Run by pressing the “ On” button. When the commands are received by the indoor
unit, the “
” light (yellow) of the receiver kit will come on briefly. Check that commands are received
well and the operation mode selected in item number three above) is set correctly. In the Test Run mode,
the red light (RUN) on the receiver kit is turned ON and the green light (TIMER) flashes (0.5 seconds ON
0.5 seconds OFF). Then set the OFF timer for two hours.
6. Halt the Test Run.
1. Test Run is halted automatically after two hours.
2. Test Run is halted by pressing “ OFF ” button.
After Test Run is finished, check that the red light (RUN) and the green light (TIMER) are
turned OFF.
5. Adjust the angle of the air louver as follows.
Verify that commands are received correctly by using the light and buzzer of the receiver kit. Use the
wireless remote controller pointing the transmitter toward the receiver.
1. Select the FAN mode by pressing the “Mode” switch.
2. Set the louver angle by pressing the “Louver” switch.
The louver direction is changed as follows.
ATTENTION:
The air louver has a control mechanism for the auto-swing function. Do not attempt to manually
move the louver by force.
1 Step
2 Step
7 Step
Auto Swing
3 Step
4 Step
5 Step
6 Step
P5415475
10
