This function is used when operating several receivers or indoor units side by side, to prevent a malfunction
because of receiving incorrect signals from the wireless remote controllers used in other areas.
Only the communication between the paired setting is possible, and four pairs (A, B, C, D) are available.
For example, the receiver designated “A” can only receive signals from the wireless controller designated
as “A”. It cannot receive signals from a wireless controller set as B, C or D.
7. Identifying Indoor Units Installed Side by Side Operation
Receiver or Indoor Unit set as “A”
A
B
Wireless Controller designated as “A”
A
B
Receiver or Indoor Unit set as “B”
Wireless Controller designated as “B”
Refer to the installation and maintenance or the Operation Manual for each receiver kit or indoor unit
setting. Depending on the type of the receiver kit or the indoor unit, only settings A, and B are available
and not C or D. In that case, set the wireless controller as A or B also.
● Purpose
● Procedures for this function
1. Press both “On Timer” and “Filter Sign Reset” for three seconds.
2. The current value set for this function will be displayed (A, B, C or D).
3. Press “ ” to change the setting in ascending order. (
A → B → C → D
)
Press “ ” to change the setting in descending order. (
A ← B ← C ← D
)
NOTE:
The setting will be recorded each time “ On” switch is pressed.
4. Press the “ Off ” button to exit this function and reset.
NOTE:
If no operation is performed for 30 seconds after this function is displayed, it will automatically end and reset.
A Mode (A)
B Mode (b)
C Mode (c)
D Mode (d)
9
P5415475
