Johnson Controls CIFC006B21S, Руководство по установке и обслуживанию

Страница: 27 / 36

PMGB0374
23
(4) Capacity Code Setting (DSW3)
No setting is required because of factory settings. This switch is utilized for setting the capacity code
which corresponds to the capacity of the indoor unit.
(3) Unit No. Setting (RSW1 and DSW6)
Setting is not required.
Indoor unit numbers are set by the auto-
address function. If an indoor unit number
setting is required, set the unit numbers of all
indoor units respectively and sequentially by
following setting positions. It is recommended
that you assign a number to each indoor unit
beginning with “1”. A maximum of 64 indoor
units per refrigerant system can be connected
to an H-LINK ll System. Though the available
numbers range from zero to 63, the applicable
number for the 64
th
indoor unit in theory
supplants the number "zero".
For the centralized control, this setting is
required.
1 2 3 4
ON
OFF
Setting Position
6
Indoor Unit Capacity
(MBH)
8 12 15
1 2 3 4
ON
OFF
1 2 3 4
ON
OFF
1 2 3 4
ON
OFF
1 2 3 4
ON
OFF
(5) Unit Model Code Setting (DSW4)
No setting is required. This is for setting the model code of the indoor
unit.
1 2 3 4 5 6
ON
OFF
1 2 3 4 5 6
ON
OFF
DSW6 (Tens Digit)
Unit No. Setting
RSW1 (Units Digit)
Setting
Position
Set by inserting
slotted screwdriver
into the groove.
Ex.) Set at No.16 Unit
DSW6
RSW1
Set No.1 Pin at ON side
Set at "6"
34
1 0
89
2
56
7
34
1 0
89
2
56
7
Factory settings for DSW6 and RSW1 are set at "0".
For the units supporting H-LINK II,
the Unit No. can be set for Max. 64 indoor units
(No. 0 to 63).
8.5 DIP Switch Settings
(1) Turn OFF the power supply to both indoor and outdoor units before adjusting DIP switch settings.
Otherwise, the setting will be invalidated and not take effect.
(2) Positions of DIP switches are shown below.