28
P5417050-rev.1
8.4.2 Cautions for Decorative Panel with Motion Sensor Kit (SOR-NED)
1. The decorative panel with a motion sensor can be connected to up to 16 indoor units by a single
wired controller. The decorative panel equipped with a motion sensor is activated even if it is
installed along with a decorative panel without a motion sensor.
2. When multiple indoor units equipped with a motion sensor are controlled by a single wired controller,
then all the indoor units must connect the communication cables to the wired controller. If not, the
indoor units equipped with a motion sensor will not be activated.
3. When two wired controllers are connected, the motion sensor can be set on only the main wired
controller. The sub wired controller is for display only.
I.U. with
Motion
Sensor
The communication cable for the wired controller.
I.U. with
Motion
Sensor
I.U. with
Motion
Sensor
I.U. with
Motion
Sensor
Wired
Controller
Wired Controller
Main: Setting is Available.
I.U. with
Motion
Sensor
I.U. with
Motion
Sensor
Wired Controller
Sub: Setting is not Available.
4. The outdoor unit model is compatible with control by means of a motion sensor kit.
5. The motion sensor function can NOT correspond with the indoor unit without a wired controller.
6. The motion sensor cannot be set from the central controller.
7. The decorative panel equipped with a motion sensor cannot be used when it is connected to
the same wired controller with an indoor unit in another refrigerant system which is set for a
simultaneous operation.
8. The room thermostat function is not available.
