www.johnnyseeds.com
37
3.
Pulling the plastic:
a. When everyone is ready, give the word, and raise
the plastic up and over the tunnel, centering it
evenly on all sides.
b. Wire a small section of plastic (maybe 2 ft.) in the
wire channel at the peak of one end of the tunnel to
hold the plastic centered and in place on that end.
c. At the opposite end, pull the plastic taut lengthwise
down the top of the tunnel and install a small
section of wire at the peak on that end.
d. Continue to wire the plastic into the channel on both
endwall hoops by working together at opposite ends
of the tunnel, wiring downward from the peak to the
hipboard on one side of the tunnel, pulling the
plastic taught lengthwise and evenly as you go.
Then, repeat for the opposite half of the tunnel.
3.a.
3.a.
3.a.
2.c.
3.b.
7617.999 Rev 06/21/2021 | AL, JG, ms
