www.johnnyseeds.com
27
c. Starting at the top and working
concurrently down both sides of the
endwall bow, wire the plastic into the
channel, keeping the plastic taut across
the face of the endwall as you go.
Continue all the way down to the
baseboards (see photo previous page).
d. Fold the plastic around the endwall bow
and over the area between first and
second bows, below the hipboard. Wire
the plastic tightly into this area and trim
off any excess. This will serve as an
overlap panel to prevent drafts caused
by the roll-up sides. Repeat this step for
the opposite side of the endwall.
e. Wire the plastic into the channel on the
endwall baseboard.
f.
Wire the plastic into the channel around
the top and sides of the door frame.
g. Wire the plastic into the channel
around each of the doors. At this
point, much of the slack plastic has
been taken up by the channel and
may be very taught. You may need
to cut the plastic between the
channel on the doors and the
channel on the frame to relieve the
tension enough to install the wire. Be
sure to pull it tight when installing the
wire. When wiring, cut the wires off
when you reach the end of each
channel.
5.d.
5.f.
5.g.
5.g.
5.g.
5.h.
7617.999 Rev 06/21/2021 | AL, JG, ms
