John Lewis JLDV 09, Инструкция по эксплуатации

Страница: 19 / 32

Residue on inside surface of
drum or drum ribs. Clean inside surface of drum and
drum ribs.
Conductance of water at
installation site differs from
standard setting of machine. Re-programme standard setting
for degree of drying (see
‘Programming options’ chapter).
Loading door does not close. Filter not in place. Install filter into place.
When a button is pressed, Err
appears on the LCD.
Washing protection. After the
start of the programme, the
option can no longer be set.
Turn the programme knob to
OFF . Set the programme again.
Drum light does not work.
Programme selector in OFF
position. Turn programme selector to any
programme.
Defective light bulb.
Replace light bulb (see next
section).
Displayed programme time
changes erratically or stays
unchanged for a long time.
Programme time is corrected
automatically depending on type
and volume of laundry and level
of dampness.
Automatic process; this is not a
machine fault.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme. Select time programme or higher
drying level (e.g. EXTRA DRY
instead of CUPBOARD DRY ).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends
automatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Changing the bulb for
interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force
centre.
Warning! When the appliance is
switched on, the interior lighting
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug.
1. Unscrew cover above the bulb (this can
be found directly behind the loading
aperture, at the top; refer to “Description
of machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket
before screwing back the door light cover. Do
not operate the dryer when missing o-ring
gasket on door light cover.
19