John Lewis JLDV 09, Инструкция по эксплуатации

Страница: 16 / 32

The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the
ALARM
button) is pressed, led above START/
PAUSE button starts flashing
temporarily in yellow. The drying
programme is not however affected by
this (laundry protection).
Drying cycle complete /
removing laundry
Once the drying cycle is complete, display
shows a blinking "
0 ", under anti-crease
and FILTER light appear dash. If the
ALARM button has been pressed, an
acoustic signal sounds intermittently for about
one minute.
The drying cycles are automatically
followed by an anti-crease phase
which lasts around 30 minutes. The
drum rotates at intervals during this
phase. This keeps the laundry loose
and free of creases. The laundry can be
removed at any time during the anti-
crease phase. (The laundry should be
taken out towards the end of the anti-
crease phase at the latest to prevent
creases from forming.) If
LONG
ANTICREASE function has
been selected, the anti-crease phase is
lengthened by 60 minutes.
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been
removed. Clean the filter.
Warning! Before you replace the
filter, please check if there is anything
inside the filter seat.
4. Turn the programme selector to OFF .
Important! Clean the filter after each drying
cycle.
5. Close the door.
16