John Lewis JLAFFS2008, Инструкция по эксплуатации

Страница: 21 / 40

3. Continue dispensing water for about
three minutes to flush the system and
plumbing connections of any impurities
(stopping to empty the glass as necessary).
The water dispenser has a built-in device that
shuts off the water flow after three minutes of
continuous use. To reset this shutoff device,
simply release the dispenser paddle.
Ice maker operation and
care
The ice maker, ice bin, and dispenser feeding
mechanism are located in the top of the
freezer compartment. After the refrigerator is
installed properly and has cooled for several
hours, the ice maker can produce ice within
24 hours. It can completely fill an ice bin in
about two days.
The ice maker produces 1.8 to 2.7 kg of ice
every 24 hours depending on usage
conditions. Ice is produced at a rate of eight
cubes every 75 to 90 minutes.
Important! Your ice maker is turned on at
the factory so it can work as soon as you install
your refrigerator. If you cannot connect a
water supply, turn the ice maker’s On/Off
switch to Off. Otherwise, the ice maker’s fill
valve may make a loud chattering noise when
it attempts to operate without water.
Using the ice maker after
installation
Before making ice for the first time, be sure to
prime the water supply system. Air in new
plumbing lines can result in two or three
empty ice maker cycles. Furthermore, if the
system is not flushed, the first ice cubes may
be discolored or have an odd flavor.
Turning the ice maker on
and off
OF F
ON
1
Ice production is controlled by the ice maker’s
On/Off power switch. To gain access to the
ice maker, pull the extra shelf out (some
models). Press the switch to the “
O ” position
to turn it Off and press to the “ I ” position to
turn it On.
The ice maker also has a built-in wire signal
arm, which automatically stops ice production
when the ice bin is full. This signal arm should
not be used to manually stop the ice maker.
21