Cruisecontrol GC55 Installation manual
24
5.3
Trouble shoot 1
Step
Action
Confirmation
1
Operate
(Does not operate: Refer to § 5.4 Trouble shoot 2)
beep and
EM-LED turns red
2
Operate
(Does not operate: Refer to § 5.4 Trouble shoot 2)
beep and
EM-LED turns red
3
Check that the power 12V is connected
correctly. Refer to § 3.3 Wiring harness connections
4
Carry on with § 5.5 Trouble shoot 3
5.4
Trouble shoot 2
Step
Action
Confirmation
1
Check that the wires of the CM are inserted in the
correct location of the 8-pin connector
(colour to colour) and locked properly.
2
check that the CM is switched
ON
CM-LED is green
3
Check the power supply- and ground connections.
4
Press the brake pedal.
EM-LED turns red,
Beep
(Does not operate: refer to § 5.7 Trouble shoot 5)
5.5
Trouble shoot 3
Step
Action
Confirmation
1
Switch the ignition completely OFF.
2
Undo the connector of the servo and connect one of the
black wires from the servo to ground; connect the other
black wire to +12V
Servo clicks once
(does not operate: servo faulty)
3
Leave these wires connected. Connect the blue wire to
ground and connect the blue/red wire to 12V
Servo cable is
pulled in
completely
(Does not operate: refer to § 5.6 Trouble shoot 4)
4
Check the connections between the EM and the servo
(in order: EM faulty)
