2
EAK0366L10A Rev. A
General Safety Information
Risk of personal injury, unsafe conditions and equipment
damage.
•
Before repairing this unit, read this instruction sheet
completely.
•
Follow and perform these instructions as written.
•
Use the proper personal protective safety equipment and
tools as applicable for the work you are performing.
•
Use a helper when lifting, handling and assembling heavy
and large parts.
•
Avoid pinching your fingers when sliding or moving parts.
•
Check and replace all damaged and worn parts as
required before returning the unit back into operation.
Not following these repair and safety instructions can result in
personal injury, unsafe conditions and equipment damage.
Repair Instructions
Cross Beam Removal
(See
Figures 1 and 2
for reference.)
1. If applicable, remove all targets from their mounts.
2. Remove the four screws attaching the end caps to the
cross beam. and then remove the end caps. Retain these
parts for reassembly.
3. Loosen and remove the four target mount brackets from
the cross beam. Note position of target mounts before
removal. Retain all parts removed in previous steps for
reassembly.
4. With the use of a helper, hold and support the cross beam
assembly while removing the hex head pivot screw (
G
).
This will allow you to remove the cross beam as an
assembly.
5. Remove all parts (
A, B, C, D ,E, F
, and
H
) from the cross
beam. Discard all parts including hex head pivot screw
(
G
).
Figure-2
Cross Beam Assembly
(See
Figures 1 and 3
for reference.)
The following steps may be competed by assembling the
cross beam as a subassembly on a workbench.
Figure-3
1. Install the four original target mount brackets onto the
cross beam. The target mounts are numbered and must
be positioned in sequence on the cross beam left to right,
with number “1” mount on the left side.
2. Install the cross beam end plates using the original self
tapping screws. Tighten the screws to 3.7 lb-ft. (4-6 Nꞏm).
3. Position the new lower mount bracket (
E
) on the center of
cross beam, then fit the new upper mount bracket (
H
) to
align with the lower bracket.
4. Attach the brackets to the cross beam using two new hex
bolts (
B
) and three new hex nuts (
A
). Apply thread locker
to hex bolts and tighten nuts to 7.4 lb-ft. (8-12 Nꞏm).
Tighten hex nuts to 2.2 lb-ft. (2.5-3.5 Nꞏm).
8"3/ */(
D
H
G
F
A
E
A
A
C
B
D
H
G
F
A
E
A
A
C
B
Содержание EZ-ADAS
Страница 1: ...TM ServiceParts Manual EAZ0139L70ARev A ...
Страница 2: ...NOTES ...
Страница 14: ...12 NOTES ...
Страница 15: ...TM Index ...
