1
This kit provides the parts and instructions required to replace
a TS100 Target Stand Leveling Foot Assembly.
Contents
See
Figure 1
for reference.
•
A
- (1) Leveling Knob
•
B
- (1) Hex Nut (M10)
•
C
- (1) Leveling Foot Assembly
•
Not Shown
- (1) Tube - Thread Locker
General Safety Information
Risk of personal injury, unsafe conditions and equipment
damage.
•
Before repairing this unit, read this instruction sheet
completely.
•
Follow and perform these instructions as written.
•
Use the proper personal protective safety equipment and
tools as applicable for the work you are performing.
•
Use a helper when lifting, handling and assembling heavy
and large parts.
•
Avoid pinching your fingers when sliding or moving parts.
•
Check and replace all damaged and worn parts as
required before returning the unit back into operation.
Not following these repair and safety instructions can result in
personal injury, unsafe conditions and equipment damage.
Repair Instructions
Removal
(See
Figure 1
for reference.)
1. Rotate and secure the cross beam into the vertical
storage position.See “
Rotating/Storing the Cross Beam
”
in the ADAS Recalibration System User Guide for
instructions.
2. In order to replace the leveling foot assembly, the unit
must be positioned on it’s side. With the assistance of a
helper, position the unit on it’s side in a manner that avoids
damaging the unit. Ensure the unit is secure before
performing the repair.
3. Remove the existing leveling foot assembly, by
unthreading the knob from the leveling foot stud and then
unthread the stud from the base plate.
4. Discard all parts removed.
Figure-1
Installation
(See
Figure 1
for reference.)
1. Thread the replacement leveling foot assembly (
C
) into
the base plate. The height from the bottom of the foot to
the base plate, must be less than 45 mm.
2. From the top side of the base plate, thread the M10 nut
(
B
) down 15mm on the leveling foot threaded stud.
3. Apply thread locker to the threaded stud and then thread
on the replacement leveling knob (
A
) until it contacts the
M10 nut.
4. While holding the knob, tighten the M10 nut against the
knob to 7.4 lb-ft. (8-12 Nꞏm).
5. With the assistance of a helper, return the unit to it’s
normal upright position.
6. Check the operation of the leveling foot and make any
additional adjustments as needed.
8"3/ */(
A
C
B
EAZ0139L61A Rev. A 10-M-19
© 2019 IDSC Holdings, LLC. All Rights Reserved. All pictures and illustrations shown are for
reference purposes only. All information including specifications herein are subject to change
without notice. IDSC Holdings, LLC, 2801 80th Street, Kenosha, WI 53143
Leveling Foot
Service Kit
TM
EAK0366L02A Rev. A
Содержание EZ-ADAS
Страница 1: ...TM ServiceParts Manual EAZ0139L70ARev A ...
Страница 2: ...NOTES ...
Страница 14: ...12 NOTES ...
Страница 15: ...TM Index ...
