John Bean EHP System I, Руководство по эксплуатации

Страница: 15 / 28

- Page 15 -
EHP Series Operation Instructions
2.2 BEAD BREAKER INSTALLATION
The side mounted Bead Breaker is shipped from the
factory dismounted for a more compact shipping pack-
age.
A. Cut the plastic tie strap which secures the Breaker
Arm to the cabinet pivot.
B. Remove the “C” clip from the top of the pivot pin, slip
the pin out of the hole.
C. Place the Breaker Arm into position and insert the
pivot pin through the top and bottom holes.
D. Replace the “C” clip retainer onto the pivot pin.
E. Locate the spring located at the rear of the pivot
mount. Place the free end of the spring onto the “ear”
located on the Breaker Arm just forward of the pivot.
HINT: You may tie a small rope or cord onto the free end
of the spring, run the cord through the hole. Pull the
spring end toward the ear and loop free end over.
2.3 AIR INSTALLATION
THE AIR INSTALLATION MUST BE MADE ONLY
BY QUALIFIED PERSONNEL.
EXCESSIVE AIR PRESSURE CAN SERIOUSLY IN-
JURE PERSONNEL AND DAMAGE THE MACHINE.
Ensure that the line pressure is within the limits re-
quired by the machine. If the pressure exceeds 170 psi
(12 bar) it is mandatory to install a pressure regulator
before the air inlet of the machine.
If the air pressure is lower than the minimum required
of 110 psi (8 bar) the clamping power of the turntable
and the bead breaker power may be insufficient for cer-
tain tires and substantially reduces tire changer perfor-
mance.
It is suggested that the air supply be equipped with a
water separator/dryer type modification for maximum
performance.
After ensuring all the above proceed as follows:
A. Connect the machine to the air supply with a rubber
hose (rated for the pressure) with an internal diameter
of no less than 1/2" (12.5mm).
WARNING!
BEFORE CONNECTING THE
MACHINE TO THE AIR SUP-
PLY BE SURE ALL PERSON-
NEL ARE CLEAR OF THE MA-
CHINE AND NO ITEMS ARE
LEFT ON THE TURNTABLE.
B. It is recommended that an air valve shut-off be in-
stalled between the shop air supply and the tire changer
in case of air line or filter failure.
C. Should you install any optional accessories, please
refer to the relevant instructions.
D. Ensure the functional ability of the air lubricator by
ensuring that the glass site bowl is filled with air lubri-
cant.
For Reference Only
For Current Info See Equiserv.com