Lescheider Weg 6-8 • D-53773 Hennef-Bierth • Tel. +49 2248 9173-0 • Fax -79 • www.kunststoff-mueller.de
20/36
8.2
Storage
The fan/s must be stored in closed dry rooms where as even a temperature as possible prevails. This
must be above 0 °C and below 40 °C. Avoid direct sunlight, high humidity and dusty, corrosive
atmospheres and substances, vibrations and shocks.
If stored or turned off for a long time the shafts must be turned once a year to keep them
rotatable. Adhere to the motor information given in the operating instructions.
Please also refer to the motor operating instructions.
8.3
Disposal
Please commission a disposal company to dispose of the equipment properly. Currently valid
environmental law must be observed.
Before disposal clean the components to prevent their presenting any environmental risk or danger to
persons.
Observe environmental rules during disposal.
9
Installation and assembly
Installation and assembly of the radial fans should only be carried out by properly qualified staff
of Joh. Mueller Kunststoff GmbH or specialists commissioned by the client for the purpose.
Before the fan unit/s is/are installed the operator must ensure all due allowance has been made for
ambient conditions of same (plastics, motor, electrical components).
The fans must be installed on a flat surface using vibration dampers and aligned horizontally.
The operator must make all due allowance for fan noise when siting them. They ought preferably to be
installed in separate rooms for noise abatement reasons.
Before connecting them to the power supply turn the rotor to ensure it moves freely.
Install piping. If the scope of the commission doesn’t include piping installation then this must be done
by the operator.
