Jocel JMFG001771, Инструкция по эксплуатации

Страница: 28 / 31

28
TROUBLE SHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord, or the power
button has been pushed off during an ice making cycle, small ice chips may be formed and
lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and
removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel cannot remove the ice-to-ice
basket. If not, please push the ice shovel gently by finger, then press
“ ”
button to restart.
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor works
abnormally with a
Buzzing noise.
The voltage is lower than
recommended
Stop the Ice maker and do not restart
until the voltage is normal.
Water shortage
indicator light is on.
1. There is no water
2. The pump is full of air
1. Add to some water until it reaches
MAX position.
2. Press
“ ”
button to restart.
Indicator lights on
display are not on
No power Turn power on
The Ice made is too
large and with pieces
sticking together.
1. Wrong ice size selected
2. Ice of previous cycles left in the
water tray
1. Select small size.
2. Take out the ice under the standby
state.
The ice making process
was correct, but no ice
came out?
1. The compressor has no
refrigerant
2. Compressor damaged
3. Fan motor damaged
Call the technical service
All indicators flash at
the same time.
1. The water box is blocked by ice.
2. The motor is stuck, or the motor
falls off, or the motor is damaged.
3. Micro switch damaged.
1. Take out the ice under the ice
shovel, plug in the power again,
and press the
“ ”
button. After 3
minutes, the machi ne will restart
automatically.
2. Call the technical service.
The machine has been
working, but the water
has been warming
Solenoid broke down Replace the solenoid valve
When the ice is full, the
machine does not
display the ice full Icon
Ice full sensor damaged
Solar light interference
1. Replace the ice full sensor
2. Move indoors to make ice
3. Call the technical service.