61
Error codes
If there is an error, the LED will flash a several times as indicated in the table below.
Cause
Interior lighting LED flashes
Failure of temperature control knob
1x
Failure of defrost temperature sensor
2x
Door doesn't colse well
3x
Troubleshooting
Caution!
Before troubleshooting, disconnect the power supply. Only a qualified electrician
of competent person must do the troubleshooting that is not in this manual.
Important!
There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance does not
work
Temperature regulation knob is set
at number “0”.
Set the knob at other number to
switch on the appliance.
Mains plug is not plugged in or is
loose
Insert mains plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
The food is too warm
Temperature
is
not
properly
adjusted.
Please look in the initial Temperature
Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulation to
a colder setting temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Appliance cools
too much
Temperature is set too cold.
Turn the temperature regulation knob
to a warmer setting temporarily.
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall
or other objects.
Move the appliance slightly.
