Jobsite CT4284, Оригинальная инструкция

Страница: 12 / 16

CHANGING A BLADE
WARNING. Always ensure that the saw is switched off and the plug is
removed from the power point before making any adjustments or changing a
blade.
•
Turn the jigsaw upside down
• Remove the blade guard
• Use the hex key to install blade
• Slide the blade guard
CAUTION. The blade roller guide supports the blade when cutting and must
at all times rest against the back edge of the blade. It should rotate freely.
SWITCHING ON AND OFF
• Connect the plug to the power point.
• Start the tool by squeezing the on/off trigger switch (1).
• Release the trigger to stop the tool.
• If you press the lock-on button (3) while the trigger switch is depressed,
the switch is kept in the operation position.
• To release the lock-on button, press and release the trigger switch.
CAUTION. Allow the blade to come to a complete standstill before setting the
jigsaw down.
MAKING A CUT
• Switch on the jigsaw and allow the blade to reach maximum speed.
• Slowly guide the jigsaw forward using both hands, keeping the base plate
(5) flat against the work piece.
NOTE. Use only enough pressure to keep the blade cutting. Do not force the
cutting, allow the blade and the saw to do the work.
Note.
When cutting metals, a suitable cooling / cutting oil must be used.
Squirt the lubricant onto the blade or work piece at regular intervals during
cutting in order to reduce wear on the blade.