Joab EcoDrive VL10U, Руководство по эксплуатации и обслуживанию

Страница: 43 / 57

37
High-Tipping-Chains
To lift, tip, or unload a skip using the high-tipping-chains, follow the normal procedures listed in
this manual. In addition, the warnings and bullet points listed below
must be adhered too.
When tipping a skip with the use of the high-tipping-chains, do not allow the angle
between the high-tipping-chains and the skip-loader's lifting-chains to exceed 140
degrees. Do not allow the angle x (shown below) to exceed 60 degrees. If these lim-
itations are exceeded, serious damage or injury
will occur. See below for further
information.
l
High tipping a skip shall only be performed with JOAB's high-tipping-chains. Do not use
any other equipment to high tip a skip. The high-tipping-chains are located at the rear of
the skip-loader, as shown above.
l
Control of the tipping action must be performed with the use of the external controls and a
good visual overview of the equipment. Do not perform the action using the cab mounted
controls.
l
When lifting the skip onto the skip-loader make sure that there is space between the bot-
tom of the skip and the skip-loader.
l
The high-tipping-chains must be attached onto the skip's tipping-hook axle. Do not attach
them to any other place on the skip.
l
Use the folding-arm and follow with the use of the lifting-arm to tip the skip.
EcoDrive VL10-VL18 manual: 1021046 Edition 2 | 2022-05-02