6
Please make sure the Mounting hardware is strong enough no any damage, and insurance for the
safety rope as auxiliary security fixed in other facilities will need to verify before installation.
Installing or removing the equipment, to make the pulley below the work location.
4.3
UA PROTECTION AND THE BULB EXPLOSION
Prohibit straight viewpoint with exposed bulbs to avoid UV damage to the eyes;
Do not use the equipment without the lens screen and the lid;
The lens and the light head covers should be timely replaced if any damage to rupture
The Fixture should be used with the protection screen together.
4.4.1
ANTI-HIGH TEMPERATURE (Rated maximum ambient temperature)
ta =40°C
Please don’t use the equipment if the temperature above 40
℃
4.4.2
ANTI-HIGH TEMPERATURE
（
Maximum outer surface temperature
）
4.5
IP PROTECTION
The product are certified at IP 20 levels only. Adequate additional protection should be taken for
outdoor use. All lamps, lights and their fittings should be kept dry. Overheating dust and excessive
humidity must be avoided.
4.6
BURST PREVENTION
The lens should be changed if had damaged or any problems. Don’t change the non-original
manufacturer lens
Len size
：￠
145*24mm
4.7
PREVENTION OF ELECTIC SHOCK
The electrical connection must only be carried out with corresponding qualifications;
Before installing, make sure you use the power voltage lamps must comply with the identified
power, voltage and have an overload or leakage protection;
Each lamp must be properly grounded, installed in accordance with the relevant standards;
Cut off the power when stall or replace the lamp and the fuse;
Prohibit the use of a lightning storm or wet environment.
4.8
MAINTENANCE
Before starting any maintenance work or cleaning the projector,cut off power from the mains
supply. After switching off,do not remove any parts of the fitting,to avoid getting burnt for at least
30 minutes.After this time the likelihood of the lamp exploding is virtually nill.
The fitting is designed to hold in any splinters produced by a lamp exploding. The lenses must be
mounted and,if visibly Damaged, they have to be replaced with genuine spares.
