SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31215090
3-3
3.5
BATTERY CHARGING
The battery charger AC input plug is located inside the frame at the
left rear of the machine next to the battery charger. Refer to Section
6.4 for battery charger specifications.
1.
Connect the charger AC input plug to a grounded outlet
using a 3 wire heavy duty extension cord.
NOTE:
Park the machine in a well-ventilated area before charging.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND GROUNDED OUTLET. DO
NOT USE GROUND ADAPTERS OR MODIFY PLUG IN ANY WAY. DO NOT TOUCH NON-INSU-
LATED PORTION OF OUTPUT CONNECTOR OR NON-INSULATED BATTERY TERMINAL.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED, OR IF THE CHARGER
HAS RECEIVED A SHARP BLOW, BEEN DROPPED, OR OTHERWISE DAMAGED IN ANY WAY.
ALWAYS DISCONNECT THE CHARGER AC SUPPLY BEFORE MAKING OR BREAKING THE
(POSITIVE/NEGATIVE) CONNECTIONS TO THE BATTERY.
DO NOT OPEN OR DISASSEMBLE CHARGER.
2.
After connecting the charger to an AC outlet at the start of
the charging cycle, verify normal operation of the LED indi-
cators on the charger (refer to Section 6.6).
NOTE:
Current battery charge state can also be seen on the platform
control station panel LEDs or the MDI indicator (if equipped) on
the ground control station when machine is powered up.
3.
The batteries are fully charged when all three GREEN LED
indicators on the platform control station or MDI battery
charger status panel are illuminated.
NOTE:
If the charger is left plugged in, it will automatically restart a
complete charge cycle if the batteries voltage drops below a
minimum voltage or if 30 days has elapsed.
To
order go
to
Discount-Equipment.com
