Continued on Next Page
SB-B-7SER/10W6v2 INSTR_SKU# 011311
s t e P 7
Install the two Allen Head Studs with Spacers (included) into
the threaded bosses as shown leaving approximately 1/2” of
the Allen Head Studs exposed.
s t e P 6
View the OEM hole that the arrow on the left is pointing to,
place the wax square on the right in approximately the same
location on the right side as indicated by the arrow. Place the
three 2”x2”x13” Foam Support Blocks in front of the armrest
opening as shown.
s t e P 5
Re-assemble the parts that have been removed from the car.
s t e P 4
Remove the rear seat back panel and set aside. This panel
will not be used.
Page 2 • JL Audio, Inc 2010
S T E P 9
The rear seat back cusion is secured at the bottom by a
number of bolts along the bottom edge, locate them and
remove them so that the back cusion can be lifted up and
forward from it’s anchor points.
S T E P 1 1
Remove the rear armrest trim panel and door remove the
door from the assembly and re-install the trim piece without
the door.
S T E P 1 0
Tilt the rear seat back cusion forward (or remove it entirely).
S T E P 8
Remove the bottom cusion of the back seat, it can be just
slid forward and remain in the vehicle if so desired.
