Continued on Next Page
SMS-F150-SPRCRW INSTR_SKU# 011341
S T E P 1 2
Using a flat blade screwdriver, carefully pry off the plastic ring
around the factory speaker as shown.
S T E P 1 6
Locate the two holes in the door as indicated.
S T E P 1 1
Remove the four screws holding in the factory speaker, then
unplug and remove the speaker.
S T E P 1 5
Pictured is the Crossover Bracket and mounting hardware.
S T E P 1 0
Pictured is the door with the panel removed and the release
handle still attached to the release cable.
S T E P 1 4
Pull away the moisture barrier and apply the Foam Tape
around the speaker hole as shown.
S T E P 9
Lift up on the door panel to slide out the clips, unplug the
harnesses, slide the release handle through the opening in
the panel, and remove the panel.
Pictured is the back side of the door panel to show the
locations of the clips.
S T E P 1 3
Using a razor knife, cut the Foam Tape lengthwise.
Page 5 • JL Audio, Inc., 2013
