15
MASTER POWER SWITCH LOCATION
To complete shut off power to the treadmill, turn off
master power switch and unplug from outlet .
ERROR MESSAGE & TROUBLE SHOOTING
E1 (Error 1):
When the machine starts but computer could not read the signal from sensor for 7 seconds, E1 will be
shown on the computer .
E6 (Error 6):
When the machine starts but computer could not read the VR signal from incline motor for 6 seconds,
E6 will be shown on the computer .
If any above trouble happens, please consult the distributor .
E3 (Error 3):
It happens only in HRC mode (H1, H2, or H3) when user
’
s heart rate is 20 beats more than target
heart rate and last for over 30 seconds . For your safety, you should stop running when E3 appears .
SMELL
If any smell comes out from motor, please firstly spray out some silicone on the running board (Please
refer to page : RUNNING BOARD MAINTENANCE), and see if the situation improves . Then consult
distributor for necessary help .
There is an ASA system (Adjustable Shock Absorber system) installed on the right side of main frame .
the
It is adjustable to change the shock intensity of the running board to reduce impact shock by 20% to
60% to protect your joints while running on it .
Turn the knob to the left to get the softer running board shock intensity . Turn the knob to the right
to get the harder running board shock intensity . Do not adjust it when some one is running on the
machine .
ASA OPERATION
