Auxiliary Telephone
innkeeper 1rx does not disconnect the auxiliary telephone when you press the
<Call>
button. You can use an auxiliary phone to place or screen a call and then
place it on hold. When you are ready to take the call on innkeeper 1rx, simply
press the
<Call>
button. Your telephone will automatically release the hold. If you
need to take the call back on the aux telephone, simply pick up the telephone
handset before the innkeeper 1rx
<Drop>
button is pressed. If you prefer to
disconnect the aux phone when the hybrid takes a call, please refer to the
Optional Jumper Settings section below for Jumpers 2 and 3.
Optional Jumper Settings
MUST BE PERFORMED BY QUALIFIED SERVICE PERSONNEL.
To change the
setting of an internal jumper, disconnect power from the hybrid before
removing the cover of the innkeeper 1rx. The default jumper position is
Closed
(covering both pins). To
Open
the jumper, remove the jumper or
cover just one pin.
WARNING!
The AC cable must be unplugged from the back of
the innkeeper any time the case is opened. Failure to follow
these instructions could result in in injury or death.
Jumper 1: Attenuation
If the incoming caller level is too high and peaking the red -3 dB LED,
change Jumper 1 to the
Open
position. This will provide 6 dB attenuation of
the incoming audio signal. This does not affect transmit level.
REPLACE AND SECURE THE COVER BEFORE RECONNECTING THE POWER CORD.
Jumpers 2 & 3: Auxiliary Telephone
In the factory default
Closed
position, the
<Line>
jack and
<Phone>
jacks
are
Bridged
.
In the optional
Open
position, the jacks are
Switched
.This means that when
the
<Call>
button is pressed, any phones connected to the phone jack of the
innkeeper are disconnected.
REPLACE AND SECURE THE COVER BEFORE RECONNECTING THE POWER CORD.
9
Configuration
Configuration