JIYI Robotics CO. Ltd
20
3、
Operation
：
switch to “ Close”–“Move to the left”–“Close”, and it will execute a
left side-move once; switch to “ Close”—“Move to the right”–“Close”, and it will
execute a right side-move once.
5.2.3Pump control function
The function is to control flow of the pump.It supports two kinds of control
modes: one is manual control mode which means output of pump is controlled by the
remote controller directly. the other is linkage mode which means when the pump is
switched on, the flow speed of the water pump is corresponding to the horizontal
flight speed of the aircraft. In other words, the higher flight speed and the larger flow.
1、
Connection :
connect the ESC signal wire of the water pump to the PUMP port on
the FCU.
2、
Setting:
connect to Assistant2 Software, configure the channel to control the water
pump.
Supporting the configurations of the PUMP by both Assistant2 Software and
APP.
Assistant Software
setting
:
connect to Assistant2 Software and enter the path of
“Adv”—“Pump”.
APP setting: use data-link to connect the FCU. Please refer to the port definitions
table.
