JinkoSolar JKMxxxM-60 Series, Руководство пользователя

Страница: 11 / 24

Rev. C
- 9 -
1) Visual check before installation, to make sure there is no bug in the packing
and junction box as well as the surface of module, If have , remove and clean it .
2) Check the series number is right or not.
3) Jinko modules are designed to meet a maximum positive (or upward) pressure of
3600Pa and negative (or downward,) pressure of 1600Pa. When mounting
modules in snow-prone or high-wind environments, Special care should be taken
to mount the modules in a manner that provides sufficient design strength while
meeting local code requirements.
4) Where common grounding hardware (nuts, bolts, star washers, spilt-ring lock
washers, flat washers and the like) is used to attach a listed grounding/bonding
device, the attachment must be made in conformance with the grounding device
manufacturer's instructions.
Common hardware items such as nuts, bolts, star washers, lock washers and the
like have not been evaluated for electrical conductivity or for use as grounding
devices and should be used only for maintaining mechanical connections and
holding electrical grounding devices in the proper position for electrical
conductivity. Such devices, where supplied with the module and evaluated
through the requirements in UL 1703, may be used for grounding connections in
accordance with the instructions provided with the module.
2.3.1 Fixation with screws
The frame of each module has 8 mounting holes (Length* Width: 14mm*9mm) used
to secure the modules to support structure. You can use the four symmetry holes
close to the inner side on module frame. If excessive wind or snow load are expected,
you must use all the eight mounting holes. The module frame must be attached to a
mounting rail using M8 corrosion-proof screws together with spring washers and flat
washers in eight symmetrical locations on the PV module. The applied torque should
be big enough to fix it steadily. Please find detailed mounting information in the below
illustration.