This document is only for internal use of JINNENG CLEAN ENERGY TECHNOLOGY LTD, and shall not be published or
copied without permission of the company.
Fig. b Fig. c
End Clamp installation Middle Clamp installation
6. Especially the installation of long side pressing blocks embedded in beam, the modules may be
mounted using clamps designed for solar modules refer to Fig.d, the modules must be supported
along the length of the long edge and should overlap the array rail by 10mm-14mm.
Rail
Clip
Frame
Support width
Catch width
5mm Min.
10-14mm
30mm Min.
Catch length
Fig. d
3.3 Stent
1. Please obey the instructions and safety regulations on racks. From bracket suppliers if necessary,
can obtain more information on support.
2. Module frame provided on the back of at least 4 fixed hole used for fixed installation, please don't in
the module of drilling hole on aluminum alloy frame, such as drilling, is likely to affect the service life
of module.
3. Module must be installed in the frame of the plane. Entire squadron composed of modules and
support system must be able to withstand the wind and snow load must produce mechanical stress.
4. A stent of heat bilges cold shrink stress should not impact on the performance of the module and
use.
5. Stent must by weather resistance, corrosion resistance, UV resistance materials, general use of