USR-WIFI232-A/B/C User Manual
http://www.usriot.com
Jinan USR IOT Technology Limited
Page 32 of 93
�
Users can easily setting and track user device through Phone/PAD and not change the
orginal network setting.
�
Users can easily setting module’s parameters through WiFi when module works as STA
mode.
AP+STA
AP+STA
AP+STA
AP+STA Mode
Mode
Mode
Mode Setting:
Setting:
Setting:
Setting:
AP+STA mode need serial AT command to enable as follows:
�
AT+FAPSTA=on, Enable AP+STA mode;
�
Then, when you configure module works as STA mode, it’s AP interface still active;
AP+STA
AP+STA
AP+STA
AP+STA Mode
Mode
Mode
Mode Notes:
Notes:
Notes:
Notes:
When user enable
AT+STA function,the STA port need to keep connected with other
router(AP),
or STA port will have to scan the AP frequently ,which will affect AP port function and may cause
some date loss.
So ,if user confirm STA port can't connect with AP at some time,user can disable the STA scan
through the following command:
�
AT+STTC=on/off,on:Scan AP;off:No Scan AP.
After re-start module,this command not saved;
�
AT+FSTTC=on/off;
This command is saved after re-staring the module;
4.4
4.4
4.4
4.4 Ethernet
Ethernet
Ethernet
Ethernet Interface
Interface
Interface
Interface Communication
Communication
Communication
Communication
USR-WIFI232-A/B/C module provides one 100M Ethernet interface. With this Ethernet interface,
user can easily realize the three interface (WiFi, UART, and Ethernet) intercommunication and
networking. USR-WIFI232-A/B/C module can configured as Bridge Mode or Router Mode base
on different networking technology.
Notes: As the Ethernet mode will increase additional consumption, so it is default closed. If you
need this function, pls use AT+FEPHY=on to open it and RELD can’t change this. For different
application, USR-WIFI232-610 need version switch via commands (such as following description
of
N-ver and Z-ver). With command AT+FVER=n to switch to N-ver and with command
AT+FVER=z to switch to Z-ver.
4.4.1
USR-WIFI232-A/B/C Ethernet Interface Networking (As AP)