7
FP4-14-GB(V4)
www.jilong.com
Operating Instructions
The filter pump will prime itself as long as it is positioned at least 8
inches below the highest water level is a relief valve located on the
top of the pump. Simply turn the valve knob counter-clockwise, and
when a small amount of water escapes, close immediately by turning
clockwise. The pump will now be completely primed.
Never operate the filter pump dry. This can cause damage to seals
which may result in leakage and/or flooding.
Prior to each use, check to ensure that all hose-clamps are tightened.
Prior to each use check to ensure that both inside wall plug caps(P13)
are open and strainer(P14)have been installed properly.
To prevent possible electric shock, do not attempt to plug in electrical
power cord with wet hand or while standing in water.
The filter pump must operate in the upright, vertical position.
The filter pump must be positioned on level, stable ground. And the
use of a riser or elevated platform is not expected.
Once you have confirmed turn on the pump by plug its electrical cord
into a ground fault circuit interrupter outlet.
To preserve the full life of the pump and to keep the pool filtered
properly , your pump should be run approximately 4 to 6 hours per day.
Overuse may cause overheating and/or motor burnout. Use good
judgment on extremely days and be mindful of running the filter pump
continuously for an extended period of time.
GFCI Test(Only For US Marketing)
The unit is provided with a ground-fault circuit-interrupter (GFCI). To
test the GFCI, push the test button. The GFCI should interrupt power.
Push the reset button. Power should be restored. If the GFCI fails to
operate in this manner, the GFCI is defective. If the GFCI interrupts
power to the pump without the test button being pushed, a ground
current is flowing, indicating the possibility of an electric shock. Do not
use this pump.
Disconnect the pump and have the problem corrected by a qualified
service representative before using.
WARNING: RISK OF ELECTRIC SHOCK. The GFCI plug must be
tested before each use.
WARNING: I
nsert the GFCI plug into a properly power receptacle only.
WARNING:
Before inserting the plug into a power receptacle, make
sure the current rate of the power receptacle and the fixed wiring are
