5
FP4-14-GB(V4)
www.jilong.com
Item No.
Description
QTY
P1
Air valve screw
1
P2
Air valve O ring
1
P3
Filter housing chamber cover
1
P4
Filter cover rubber ring
1
P5
Filter
1
P6
Body
1
P7
Seal O ring
1
P8
Power cable
1
P13
Filter Net Only for 300&530gal
2
P14
Connector Only for 300&530gal
2
Installation Instructions
Set up your Storable Pool exactly. Fill it completely with water.
Position the filter pump unit at least 8 inches below the highest water
level in the pool.
And keep the filter pump at least 2 feet away from the sidewall of the
pool.
Place filter cartridge into the body of the filter pump.
Make certain that the filter chamber rubber gasket is placed in the
seal groove on the top of the filter pump.
Screw on filter chamber cover onto top of the body of filter pump by
hand.
Connect the hoses same as the Installation illustration, fixture the
pump to the wall of pool. Remember to use hoseclamp, tighten it
secondly with screwdriver.
Open both wall plug caps (P13)on the inside of the pool an plug in a
strainer(P14)for each.
Allow time for filter pump chamber to full with water. Never operate the
filter pump dry.
Connect electrical power cord into a grounded receptacle protected
by a ground-fault circuit interrupter (GFCI).Please contact a qualified
electrician for verification purposes and/or installation of a GFCI
receptacle if necessary.
