Quick-Start Guide
Mount an iPad
Jigabot EX
Confidential & proprietary. Copyright 2022 Jigabot LLC, all rights reserved. [email protected] www.Jigabot.com Ph. 801-995-3680
Once you verify how to track with your Jigabot EX, you can attach an iPad as
follows:
First power OFF your Jigabot and DOTdriver, then do this setup:
1. Attach the Ball Head mount to the Jigabot EX
2. Attach the iPad Mount to the Ball Head mount
3. Attach the iPad to the iPad Mount Accessory
Again power ON, then stand 6 feet in front of the Jigabot EX and move the
DOTs slowly from side to side. Congratulations, you’re tracking with an iPad!
STEP 3
Screw in
Ball Head
Mount
to EX Bot.
NOTE: tighten
Ball Head nobs
first.
Screw in
Tablet
Mount
into the Ball
Mead Mount
Attach the iPad to the iPad Mount
Follow steps A, B, C below:
(B) Rest your
iPad
on the iPad
Mount
(bottom of iPad
into the base
channel)
(A) Extend up
the
iPad Mount
(just above the
height of your
iPad)
(C) Place top
of iPad in top
channel
(push top of
mount down to
hold iPad firmly
in position)
STEP 1
STEP 2
